Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for MACTRAP GREASE BOSS G15 EASY CLEAN
Summary of Contents for MACTRAP GREASE BOSS G15 EASY CLEAN
- Page 1 OPERATIONAL MANUAL MACTRAP GREASE BOSS G15 EASY CLEAN AUTOMATIC GREASE REMOVAL UNIT (GRU) EDITION 2019 Supplied by: MACTRAP LTD Phone: +64 7 549 0414 Mobile: +64 274 978 791 Email: info@mactrap.co.nz www.mactrap.co.nz Manufactured by MACTRAP Katikati New Zealand We capture fats, oil & grease...
- Page 2 <350L passive capacity Operation FOG Removal Rate <11.kg/Hour <20kg Grease Retention Heating Uses operator’s sink waste and hot water connected to hot water supply For more information contact MACTRAP Phone: +64 7 549 0414 Mobile: +64 274 978 791 Email: info@mactrap www.mactrap.co.nz...
- Page 3 Check correct invert levels herein shown. • HW temperature at sink should be >41oC for average daily operation but below scald temperature to allow entry and service. For more information contact MACTRAP Phone: +64 7 549 0414 Mobile: +64 274 978 791 Email: info@mactrap www.mactrap.co.nz...
- Page 4 (Note the fault light also occurs when the lid is open). PROGRAMME The PLC will display which operation is taking place, or if there is a fault. For more information contact MACTRAP Phone: +64 7 549 0414 Mobile: +64 274 978 791 Email: info@mactrap www.mactrap.co.nz...
- Page 5 WARRANTY A 12 month warranty applies to parts and materials for this MACTRAP GRU. This warranty does not include any labour, cleaning out or maintenance. If the MACTRAP GRU is not installed and operated as per these operation guidelines, the warranty will be void.
- Page 6 To assist and limit problems of internal solids build up, before pre-wash rising, wipe any dairy waste off dishes /utensils into rubbish. • We recommend permanent sink solids filters be used in addition to the MACTRAP filter basket. • Use hot water for washing...
- Page 7 If the roller motor does not display “ON”, the motor must be checked by Mactrap for possible replacement. MAKE SURE WIPER BLADE ASSEMBLY IS SECURE Position wiper blade assembly over the oil chute guide and secure to locator plate.
- Page 8 Boss is programmed for safe efficient operation so this aspect should only need checking during annual service. Refer to service agent or Mactrap for assistance. CHECK WATER FLOW Make sure that the water flow to the unit does not exceed the rated flow and that there are no drain line blockages downstream from the unit.
Need help?
Do you have a question about the GREASE BOSS G15 EASY CLEAN and is the answer not in the manual?
Questions and answers