Table of Contents
Advertisement
2.3.7 Restoring/Updating Platform via SD Card
2.3.7.1 Preparing the SD Card
2.3.7.2 Updating the AP Controller with Micro SD Card
A6V11164550
Before you begin, prepare the SD Card by following the steps below:
1. Insert the Micro-SD (2 GB minimum) card into the computer. (Use a Micro-SD
to SD Card adapter, if required)
~.7z
2. Unzip the
file (in
the ".img" file. (This file can be opened using the
can be downloaded from the internet, if not already installed on your computer.)
Win32DiskImager
3. Use
~.img
the
file to the SD Card.
Note: The disk imager program must be installed on your computer, not on the
Micro-SD card.
Note: In case of SD Card update, the database configuration and system settings
will be lost.
1. Power down the controller and open the case to expose the circuit board.
2. Insert the Micro SD Card in the slot, as shown in the picture.
3. While holding down the Factory Reset Button, switch the unit on. Release the
button after 5 seconds.
The LED will show the following states as the controller is booting and
updating:
–
RED: The controller is starting up.
–
Flashing ORANGE or GREEN: The controller is in different stages of the
update.
–
Steady ORANGE: When the LED turns to steady ORANGE, wait 7 seconds
till update is finalized.
4. Remove power from the controller, remove the SD card, and restart.
Note: LED flashing RED at any stage indicates an error in the update process. In
this case, repeat the steps above to begin update again.
Once the controller is powered up, the network settings must be configured as
described in Section Configuring the ACC USB Client Application [➙ 5].
The AP Controller is now set up and can be connected to SiPass integrated.
Firmware\ACC\AP01P (AP)\SD_Card folder
Tools\ACC-G2 SD-Card Creator Tool
(in
Access Controllers
ACC-AP
) to extract
7-zip
file archive utility which
folder) to write
25 | 38
2
Advertisement
Table of Contents
