Auto Restart Setting - Carrier 42TGF CP Series Installation Manual

Wireless remote controller
NOTE
Be sure to operate the unit, following the instruction
manual
Do not run the air conditioner in forced cooling mode
for a long time since it overloads the air conditioner.
1
Hold down the TEMPORARY button for over
10 seconds. With a beep sound, the unit is
set to the forced cooling mode.
In approximately three minutes, it is forced to start
in cooling mode. Determine that cool air comes out
of the unit. If the unit won't start, check the wiring.
2
Push the TEMPORARY button again (for about
one second) to stop a trial run.
The upper and lower wind direction changing
blades close, and the unit stops operation.
37-EN
Checking remote transmission
1. Push the ON/OFF button on the remote controller to
determine that it works properly.
Pushing the TEMPORARY button once (for about
one second) causes the unit to enter auto operation
mode. Hold down the TEMPORARY button for over
10 seconds to begin forced cooling.
Even if you select cooling with a remote controller,
the unit does not always perform cooling operation,
depending on temperature conditions. Check the
wiring and piping of the indoor and outdoor units in
forced cooling mode.
TEMPORARY button
– 19 –
10

Auto restart setting

This product is designed so that, after a power failure,
it can restart automatically in the same operating mode
as before the power failure.
Information
The product was shipped with Auto Restart function in
the on position.
How to cancel the Auto Restart
Auto restart (wired remote controller)
(When performing this task, be sure to use a wired
remote controller)
<Procedure> Perform setting while the air conditioner
stops.
1
Push + + buttons simultaneously
for 4 seconds or more.
The rst displayed unit No. is the master indoor
unit address in the group control.
In this time, fan and louver of the selected indoor
unit operate.
2
Every pushing button (button at
left side), the indoor unit No. in the group
control is displayed one after the other. In
this time, fan and louver of the selected
indoor unit only operate.
3
Using the set temperature
specify the CODE No. (DN).
4
Using the timer time TIME buttons, select
the set data.
5
Push button. (OK if indication lights)
To change the selected indoor unit, proceed to
2
Procedure .
To change item to be set up, proceed to
3
Procedure .
6
Pushing button returns the status to the
normal stop status.
TEMP.
3
TIMER SET FAN
6 TIME SAVE
FILTER
RESET TEST SET CL SWING/FIX
Setting
1
DN Item Description
Automatic 0000: 0001:
restart None Restart
28
of power
failure
buttons,
ON / OFF
MODE
4
VENT
5
UNIT LOUVER
2
At
shipment
0001:Restart
38-EN