Installation On A Wall Using A Screw/Peg - FLORABEST HG00249 Operation And Safety Notes

Push the point of the ground spike into soft earth. Never use
force.
Push the open end of the ground spike in the device's ground
spike holder
Point the device, so that the motion sensor
wards the area you wish to monitor. Make sure that the area
you wish to monitor is not blocked by objects, such as trees or
garden furniture.

Installation on a wall using a screw/peg

Use the enclosed peg
the device on a wall. This installation material is intended for a
normal wall. If the wall you wish to install the device on has a
different consistency, check with a specialist to find out which
material is suitable for installation on your wall.
Ensure the screw
Allow the screw to protrude approx. 1 cm from the wall and
use the loop
Operation
The device has two adjustment options:
.
11
(Ø 6 mm) and the screw
17
is a maximum of 1.5 m above the ground.
16
to hang the device on the screw.
7
is pointed to-
5
to install
16
GB/IE 15