Sharp AN-SS2 Operation Manual page 8

IMPORTANT SAFETY INSTRUCTIONS (continued)
17) Object and Liquid Entry - Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short-out parts that could
18) Damage Requiring Service - Unplug this product from the wall outlet and refer servicing
a. When the AC cord or plug is damaged,
b. If liquid has been spilled, or objects have fallen into the product.
c. If the product has been exposed to rain or water
d. If the product does not operate normally by following the operating instructions.
Adjust only those controls that are covered the operating instructions as an improper
adjustment of other controls may result in damage and will often require extensive
e. If the product has been dropped or damaged in any way, and
f. When the product exhibits a distinct change in performance - this indicates a need
for service.
19) Replacement Parts - When replacement parts are required, be sure the service
shock, or other hazards.
20) Safety Check - Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks to determine that the product is in proper operating
condition.
21) Wall or ceiling mounting - When mounting the product on a wall or ceiling, be sure to
install the product according to the method recommended by the manufacturer.
22) Power Lines - An outside antenna system should not be located in the vicinity of overhead
power lines or other electric light or power circuits, or where it can fall into such power
lines or circuits. When installing an outside antenna system, extreme care should be
taken to keep from touching such power lines or circuits as contact with them might be
fatal.
23) Protective Attachment Plug - The product is equipped with an attachment plug having
overload protection. This is a safety feature. See Instruction Manual for replacement or
resetting of protective device. If replacement of the plug is required, be sure the service
same overload protection as the original plug.
24) Stand - Do not place the product on an unstable cart, stand, tripod or table. Placing the
product on an unstable base can cause the product to fall, resulting in serious personal
injuries as well as damage to the product. Use only a cart, stand, tripod, bracket or
table recommended by the manufacturer or sold with the product. When mounting
the product on a wall, be sure to follow the manufacturer's instructions. Use only the
mounting hardware recommended by the manufacturer.
n the apparatus.
mal operation,