Storage; Outdoor Installation; Operational Environment - Harrington Hoists RHN02D-20A-20D Series Owner's Manual

Electric wire rope hoist and trolley rhn series 2 ton through 20 ton capacity
Table of Contents

Advertisement

RHN02, RHN03,RHN05, RHN08, RHN10 Trolley Hoist
11. Operate the hoist several times up and down (without a load) for the entire length of the lift.
12. Repeat with increasing loads
13. Inspect for twist while operating the hoist. Severe twist will cause the bottom block to turn. This is easily
noticeable when there is no load on the hook. Always make sure that the rope is free of twist prior to
lifting a load to prevent permanent distortion, rope damage, or rope guide damage.
14. If the wire rope has twisted, repeat steps 1-10 until twist is no longer present.
6.7

Storage

6.7.1
The storage location should be clean and dry.
6.7.2
Care should be take to not damage any of the electrical power cords or fittings.
6.8
Outdoor Installations
6.8.1
For trolley and hoist installations that are outdoors, the trolley and hoist MUST be covered and protected from
the weather at all times.
6.8.2
Avoid trolley hoist oxidation by using suitable treatment and lubricating all mechanisms.
6.8.3
Possibility of corrosion on components of the trolley increases for installations where salt air and high humidity
are present. The hoist and trolley may require more frequent lubrication. Make regular inspections of the unit's
condition and operation.
6.8.4
For hoist installations where temperature variations introduce condensation into the hoist additional
inspection and more frequent lubrication may be required.
6.8.5
Refer to
6.9

Operational Environment

6.7.1
Non-conforming environment
A non-conforming environment is defined as one with any or all of the following.
Explosive gases or vapor.
Organic solvents or volatile powder
Excessive amounts of powder and dust of general substances
Excessive amount of acids or salts
Anchorage Configurations (Continued)
Figure 6-23
Section 2.1.3
for allowable environmental conditions.
Table 6-3
"a" and "b" dimensions
Hoist Model
RHN02
RHN03
RHN05
RHN08
RHN10
RHN15
64
(mm)
a
b
216
241
265
290
334
366

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents