Panasonic MJ-J176PWTC Service Manual page 10

5.2.3. SYMPTOM : The spinner is difficult to install and remove
The clutch pin of the cutter base doesn't operate smoothly
Foreign materials are clogged between the cutter base and the spinner
base
5.2.4. SYMPTOM : Juice is poorly extracted
Cutter doesn't operate well
Spinner is broken
Continuous use for a long period
Too large a gap between inlet bottom and cutter blade
5.2.5. SYMPTOM : Juice contains too much residue
Cutter blade is worn out
Gap between inlet bottom and cutter blade is too large
5.2.6. SYMPTOM : Cutter rubs against inlet bottom
Gear incompletely engaged between cutter base and spinner
Too many adjustment rings on the motor shaft
5.2.7. SYMPTOM : Leakage of juice
Container and/or cover deformed or broken
Incorrect clasp fastening
Foreign materials are clogged between the container cover and the
container
Excessive vibration
Cause
Cause
Cause
Cause
Cause
Examine the clutch pin; replace it if necessary
Remove them
Replace complete spinner
Replace complete spinner
Remove the residue
Adjust it within the range of 0.5 - 0.9mm
Replace the spinner (complete)
Use two or three adjusting washers on the motor shaft
Engage the gear
Decrease the number of adjustment rings and adjust the gap within the
range of 0.5 - 0.9mm
Replace the container or cover
Examine the clasp; adjust the fastening force
Clean it and remove them
Clean it and adjust the spinner balance
10
Remedy
Remedy
Remedy
Remedy
Remedy