What To Do When; Navigenio And App - AMC Navigenio User Manual

EN
4. What to do when ...
... you hear the Navigenio beep and the Navigenio heating system does not switch on or automatically
switches off.
ƒ
”
”
For the safety of the user and the appliance, the Navigenio is set up so that it cannot be operated if
it is not safely positioned or if it is overheating.
Cooking plate function:
ƒ
”
ƒ
”
ƒ
”
ƒ
”
Overhead function:
ƒ
”
ƒ
”
The Navigenio only stops beeping once the user activates the control knob. If the beeping does
not stop, unplug the power cord from the power socket and contact the AMC Service Center.
5.

Navigenio and app

The Navigenio is equipped with a Wi-Fi module that enables remote access to the app.
18
Both in the cooking plate function and in the overhead function, a safety switch turns
off the Navigenio's heating system if it is improperly used for a prolonged period.
Set the control knob to "0" and let the Navigenio cool.
In this case, the Navigenio must always be switched to the "0" position. The Navigenio may
only be put back in operation once it has cooled down sufficiently.
The Navigenio is already switched on to level 1–6 before the power cord is plugged into
the power socket.
Set the control knob to "0" and turn to the desired level (1–6) before cooking.
The Navigenio is switched on and set to "A"; the cooking process has not started within
1 minute with the Audiotherm on.
Set the control knob to "0" and turn to "A" again, start the desired cooking process with the
Audiotherm.
The Navigenio is switched on and set to "A"; the cooking process started but was interrupted
by an external influence.
Set the control knob to "0" and turn to "A" again, then restart the desired cooking process
with the Audiotherm.
The Navigenio is switched on and is lifted off of the countertop or turned over for a longer
period of time.
Place the Navigenio on a stable and level surface, set the control knob to "0", and turn to
the desired level (1–6) or "A" again.
The Navigenio is already switched on and has been placed overhead on a pot.
Properly place the Navigenio on top of the pot, set the control knob to "0", and turn to the
desired level: small "–" or large "=".
The Navigenio is switched on and is lifted off of the pot and turned over for a longer period of
time.
Properly place the Navigenio back on top of the pot again, set the control knob to "0", and
turn to the desired level: small "–" or large "=".