ACTi R72FT-31 User Manual

ACTi R72FT-31 User Manual

Face recognition reader & controller

Advertisement

Quick Links

Face Recognition Reader &
Controller
User's Manual
R72FT-31
2021/04/09

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R72FT-31 and is the answer not in the manual?

Questions and answers

Summary of Contents for ACTi R72FT-31

  • Page 1 Face Recognition Reader & Controller User’s Manual R72FT-31 2021/04/09...
  • Page 2: Regulatory Information

    2. This device must accept any interference received, including interference that may cause undesired operation. Now that the camera and the PC are both having their unique IP addresses and are under the same network segment, it is possible to use the Web browser of the PC to access the camera. www.acti.com...
  • Page 3 L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. www.acti.com...
  • Page 4: Safety Information

    Dispose of used batteries according to the instructions  If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the device yourself. (We shall not assume any responsibility for problems caused by unauthorized repair or maintenance.) www.acti.com...
  • Page 5 Indoor use. The device should be at least 2 meters away from the light, and at least 3 meters away from the window.  Outdoor use or use in environment exceeding the device temperature measurement will affect the temperature measurement accuracy. www.acti.com...
  • Page 6: Table Of Contents

    Wall Mounting ..................13 Initial Settings ............15 Step 1: Login .................... 15 Step 2: Configure Wired Network Settings ..........16 Basic Operation ............ 17 Main Screen....................17 Home Menu ....................18 Menu Tree ..................... 19 Tips in Picture Taking ........... 20 www.acti.com...
  • Page 7: Introduction

    USER’S MANUAL Introduction Package Content  Face Recognition and Temperature Reader & Controller  Mounting plate  Wrench  Lock screws for mounting plate (x2)  Screw pack  Cable  Quick start guide  Drill template www.acti.com...
  • Page 8: Physical Description

    USER’S MANUAL Physical Description Item Item Thermographic Module Card Slot (reserved) White Light USB Port Thermographic Module IR LED Connector Cameras Power (Cable Connector) Touch Screen Terminal (Cable Connector) Card Sensor Speaker Tamper Key USB Port Ethernet Port www.acti.com...
  • Page 9: Wiring

    Terminal Description Group Function Color Name Description +12 V 12 VDC Power Supply Group A Power Input Black Ground Yellow/Blue Alarm Input 1 Alarm Input Yellow/Black Ground Group B Yellow/Orange Alarm Input 2 Alarm Output Yellow/Purple Alarm Output Wiring www.acti.com...
  • Page 10 WG_OK Authenticated Wiegand Wiegand Orange WG_ERR Authentication Failed Purple BUZZER Buzzer Wiring Tampering Alarm Gray TAMPER Wiring White/Purple Lock Wiring (NC) White/Yellow Common Group D Door Lock White/Red Lock Wiring (NO) Yellow/Green SENSOR Door Contact Yellow/Gray Exit Door Wiring www.acti.com...
  • Page 11: Wiring Common Devices

    12 V, 1 A. The recommended power supply for Wiegand card reader is 12 V,  Do not wire the device to the electric supply directly. Wiring Secure Door Control Unit  The secure door control should connect to an external power supply separately. The suggested external power supply is 12V, 0.5A www.acti.com...
  • Page 12: Installation

    The device should be installed at least 2 meters away from light, and 3 meters away from the window or door.  Make sure the wall can bear three (3) times the weight of the device. Installation Height Recommended installation height of device = 1.43 m to 1.9 m www.acti.com...
  • Page 13: Wall Mounting

    3. Insert the screw sockets into the drilled holes. 4. Align the holes to the mounting plate with the drilled holes. 5. Route the cable through the cable hole of the mounting plate, and connect the external devices cables. www.acti.com...
  • Page 14 6. Align the device with the mounting plate and hang the device on the mounting plate. 7. Use the two (2) supplied lock screws to secure the device and the mounting plate. NOTE: When the screw head is beneath the device surface, then the device is secured. www.acti.com...
  • Page 15: Initial Settings

    Step 1: Login 1. Long tap the screen for 3 seconds to enter the Login page. 2. Enter the Activation Password provided by your ACTi sales agent. 3. Type the activation password to login. 4. After authentication, the Home Menu will appear.
  • Page 16: Step 2: Configure Wired Network Settings

    Enable DHCP, the system will assign IP address, subnet mask, and gateway automatically.  Disable DHCP, you will need to manually set the IP address, subnet mask, and gateway. NOTE: The device IP address and the computer IP address should be in the same IP segment. www.acti.com...
  • Page 17: Basic Operation

    The Main Screen shows the date and time and status icons on the upper part of the screen. On the bottom part are shortcut key icons. These functions need integration and are not readily available. Contact your system integrator for details. www.acti.com...
  • Page 18: Home Menu

    Communication Network settings, almost all configurations can be done through the Access Control Server thus the Home Menu is rarely used. NOTE: This photo is for reference only, icons and the menu position may slightly vary on this documentation. Follow the actual menu on the device. www.acti.com...
  • Page 19: Menu Tree

    You will need to plug in a USB flash drive to import/export data. The Log menu allows you to check the log data of a card, ID or user name. Enable or disable Temperature Detection and set alarm threshold. Temp Info. Shows system information, serial number of device, and other information. www.acti.com...
  • Page 20: Tips In Picture Taking

     Keep expression natural Expression  Do not wear hat, sunglasses and other accessories  Do not allow hair to cover your eyes, ears, etc.  Do not use heavy makeup Posture Face should be facing the camera. Size www.acti.com...
  • Page 21 Copyright © 2021, ACTi Corporation All Rights Reserved 7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu District, Taipei, Taiwan 114, R.O.C. TEL : +886-2-2656-2588 FAX : +886-2-2656-2599 Email: sales@acti.com...

Table of Contents