Advertisement
3.7.3 Data format: starting spaces
3.7.4 Calibration: no calibration
3.7.5
Output pins content (9-core socket): 2 pins: RXD
GND
3.7.6 Computer can control balance though RS232. The orders to balance are:
1BH+70H: sending data
1BH+71H: calibration (like "CAL")
1BH+72H: Counting activated
1BH+73H: Units change
1BH+74H: Tare
3.7.7
software download in our homepage
www.gandg.de
Attachment:
Attachment:
settings
settings
Attachment:
Attachment: settings
settings and
1. Press "CAL" and do not loose till "F----3" (Balance should be switched on)
.
change the values of parameters.
2. C1------ sensitivity setting 0 1 2 3 4, the larger number is, the less sensible but
the better stable. Default setting is 2 or 1
3. C2------filtering strength setting 0 1 2 3, the larger number is, the lower
reaction speed, but the better stable. Default setting is 2 or 1
4. C3------Baud rate setting 2(600) 3(1200) 4(2400) 5(4800) 6(9600). Default
setting is 2
5. C4------communication setting. "TARE" changes the lower unit. "COUNT"
changes the higher units. This data is the first data during communication.
Default setting is 27.
6. Re-pressing "CAL" after setting. Then the balance is auto calibrated to 0.
2unit
and
and
meanings
meanings
and meanings
meanings
And pressing "CAL" can change the parameters; pressing "TARE" can
data
symbol
7units
3unit
ending
enter
1 unit
1 unit
3 pins: TXD
5pins:
Advertisement
