Table of Contents
Advertisement
2 SENSOR CALIBRATION
Every nke sensor is adjusted at the factory. However, a calibration is required to adapt the
sensor to the specificities of your boat and to obtain an optimum measurement accuracy.
Follow the calibration procedure below, by visualising the settings on a display.
Please refer to the installation notice of the TOPLINE sensor that you wish to calibrate
2.1 Setting procedure of the calibration coefficient:
TL 25
BOAT SPEED
16.85
NOEUDS
APP WIND A
105
1
DEGREES
COMPAS HEAD
274°
DEGREES
nke
2
TL 25
UNIT
KNOTS
TL 25
3
CALIB COEF
TL 25
4
CALIB COEF
1.20
TL 25
5
BOAT SPEED
16.85
KNOTS
CAUTION :
The calib coef parameter is a multiplier coefficient. This value must never be equal to
-
zero. By default this coefficient is set to 1.00. If it is not the case, before starting a
calibration enter the value 1.00.
2.2 Offset setting procedure
Follow the above procedure and select the OFFSET sub-channel.
Note that the offset default value is 0.
Using the key
, select the channel,
you wish to set the coefficient of calibration.
The selected channel flickers.
In order to access to the list of sub-channel
press and hold downthe key
, until the sub-channel UNIT appears then release.
Press successively the key
, set the new coefficient 1.20
Using
Validate and exit by maintinning
The coefficient is saved in memory
Figure 12
- 19 –
UNIT, CALIB COEF & OFFSET,
Ent
Ent
to select CALIB COEF.
Ent
TL25 User guide–- 33-60-021-000
.
Advertisement
Table of Contents
