Candy PVD 603 Instructions For Use And Installation page 54

PROBLEMS AND SOLUTIONS
The hob does not operate.
The hob does not cut off
The hob stops automatically
Frequency of on/off operations
for cooking zones
"H" display, residual heat
indicator, blinking
54 -
• A big spill or object covers at least two buttons, for
at least 10 seconds. Clean up the spill or remove
the object.
• The control panel is locked. Press the "Locking"
button to release.
• The control panel is locked. Press the "Locking"
button to release. Refer to the section, "Operating
time" page 49.
• A spill covers at least two buttons for more than
10 seconds; the hob switches to safety, and an au-
dible beep sounds so long as the buttons are cov-
ered. Clean up the spill or remove the object.
• The cooking zones stop automatically if they are
left on for too long. Refer to the section, "Operating
time" page 49.
• The on-off cycles vary according to the required
heat level:
- low level: short operating time,
- high level: long operating time.
• The electronic temperature is too high. A techni-
cian should verify the fitting in compliance with the
recommendations, page 41 & 42.