Table of Contents
Advertisement
Troubleshooting
Problem
Possible Cause and Solution
Unit fails to
Unit is not plugged in. Plug Power Cord into electrical outlet.
power on.
Tip-over switch is not making contact with the floor. Place heater on a level surface to ensure tip-over switch is mak-
ing full contact with the floor.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker / ground fault
interrupter, or replace fuse (See OPERATING TIPS below).
The unit has overheated. Automatic Safety Shut-Off has been initiated (See RESETTING YOUR VORNADO HEATER on
page 8).
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Unit is not pro-
Ensure unit is set to highest Temperature setting.
ducing sufficient
amount of heat.
Close all doors and windows to retain heat.
Allow the unit to fully distribute the heat throughout the room, this may take several minutes.
Unit power on but
Power off and unplug the unit. On the bottom of the unit, there is a black disk. Push in 4-5 times ensuring it is not
there is no heat.
stuck. Set unit down on flat surface. Be sure power cord is not under unit. Plug unit in and power on. Turn to high-
est heat setting.
10 English
Advertisement
Table of Contents
