Related Manuals for Monsoon MON-CONT
Summary of Contents for Monsoon MON-CONT
- Page 1 MON-CONT MON-CONH Installation and Wiring Instructions 220-240V~50Hz IPX4 PLEASE READ INSTRUCTIONS IN CONJUNCTION WITH ILLUSTRATIONS. PLEASE SAVE THESE INSTRUCTIONS.
- Page 2 IMPORTANT: READ THESE INSTRUCTIONS BEFORE COMMENCING THE INSTALLATION DO NOT install this product in areas where the following may be present or occur: • Excessive oil or a grease laden atmosphere. • Corrosive or flammable gases, liquids or vapours. • Ambient temperatures higher than 40°C or less than –5°C.
-
Page 3: Installation
DESCRIPTION The MON-CON 100mm fan is a continuously running extract fan for kitchens, utility rooms, bathrooms and toilets. The fan can be wall or panel/ceiling mounted. A. INSTALLATION Siting fan. IMPORTANT: The fan should only be used in conjunction with fixed wiring. PANEL/CEILING MOUNTING For panel/ceiling mounting the fan should be installed into a closed duct system of at least 1.2m long or protected by an exterior air grille that must comply with the... - Page 4 B. WIRING. WARNING: THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE ISOLATED FROM THE POWER SUPPLY DURING THE INSTALLATION / OR MAINTENANCE. IMPORTANT The fan should only be used in conjunction with fixed wiring. The cross - sectional area of supply cord used should be ranged from 1 -1.5mm ...
- Page 5 TIMER ADJUSTMENT (T & H MODELS) (FIG. 7) BEFORE ADJUSTING THE TIMER, SWITCH OFF THE MAINS SUPPLY. TIMER SHOULD ONLY BE ADJUSTED BEFORE OR DURING INSTALLATION IMPORTANT NOTE:- ON T & H MODELS THE TIMER IS ACTIVATED VIA THE LS CONNECTION.
- Page 6 Fig.1 Continuous trickle (6l/s or 9l/s) with no boost facility (T, H) Fig.2 Continuous boost (15l/s or Max) with no trickle facility (T & H) Fig.3 Continuous trickle with boost facility (T & H ONLY) Fig.4. Removing the grille for wiring and setting the controls 2.
- Page 7 Fig.5. Accessing the control settings Fig.6. Removing the front grille panel for cleaning. Fig.7. Trickle speed selection and T/H adjuster pots Fig.8. Boost speed selection Max = Timer Humidistat adjustment adjustment 15l/s = JP1 Jumper Dip switch 9l/s = Remove Jumper Connector 6l/s = Replace Jumper Connector (factory set) Max speed boost: Dip switch 2 in the...
- Page 8 National Ventilation Stathe Road Burrowbridge Somerset TA7 0RY Website: www.nationalventilation.co.uk email: info@nvagroup.co.uk Sales and technical hotline: 01823 690290 479791A 0319...
Need help?
Do you have a question about the MON-CONT and is the answer not in the manual?
Questions and answers