Maintenance And Cleaning - Princess Silver Fresh User Instructions

The time difference is then 9 hours and
30 minutes.
Use the TIMER buttons to set the delay
to 09.30. Use the TIMER+ button to
increase the time by 10 minute intervals
and the TIMER– button to decrease the
time by 10 minute intervals.
The set time includes the time required
for the chosen baking program. In this
example, the breadmaker will finish
baking the bread in 9 hours and
30 minutes.
4 Press the START/STOP button to start
the timer. The flashing dot between the
hours and the minutes indicates that
the timer is counting down. The display
shows the time remaining until the end
of the program.
Maintenance
and cleaning
• Do not immerse the appliance in
water, or in other liquids. If this was to
happen, do not use the appliance
again and dispose of the appliance for
safety reasons.
• Never use corrosive or scouring
cleaning agents.
Always clean the appliance and the
accessories after each use. This will
prevent food residues from baking onto the
appliance.
• Remove the plug from the wall socket,
and allow the appliance to cool down
completely.
• If the kneader remains in the baking tin
after baking, then fill the baking tin with
warm water, allow it to soak for five
minutes and then remove the kneader.
• Clean the baking tin and the kneader
with a damp cloth and a small amount of
washing-up liquid. Dry them thoroughly.
Silver Fresh Breadmaker/Royal Fresh Breadmaker Article 151942/151943
• Clean the interior and exterior of the
housing with a damp cloth.
Safety
General information
• Please read these instructions
carefully and retain them for
reference.
• Use this appliance only in accordance
with the instructions.
• This appliance is intended solely for
domestic use.
• Keep the appliance out of the reach of
children, and of persons who may not
be able to operate it safely.
• Have the appliance repaired only by a
qualified electrician. Never try to
repair the appliance yourself.
Electricity and heat
• Before use, verify that the mains
voltage is the same as that indicated
on the type plate on the appliance.
• Plug the appliance into an earthed
wall socket.
• Always remove the plug from the socket
when the appliance is not in use.
• Always remove the plug from the wall
socket by pulling on the plug, not the
power cord.
• Do not use the equipment if it is
damaged, or if the lead is damaged.
Send it to our Service Department in
order to avoid a hazard. With this type
of appliance, a damaged cord should
only be replaced by our Service
Department using special tools.
• Make sure that the appliance and the
power cord do not come in contact
with sources of heat, such as a hot
hob or naked flame.
11