Table of Contents
Advertisement
3.2 BACK
POWER CONNECTOR
Connect a 16-pin Eurorack power cable.
JUMPER SETTINGS
The PITCH and GATE outputs can be connected to Pitch and Gate signals on the
Eurorack power connector.
•
Gate: Set to connect Gate output to Gate signal on power connector.
•
Pitch: Set to connect Pitch output to Pitch signal on power connector.
DIP SWITCHES 1 TO 4
Use the DIP switches to map MIDI Control Change Number, Channel´s Pressure
(Aftertouch) or Note On Velocity to CC Output (see table 1) or enter Calibration Mode (see
chapter 5. CALIBRATION MODE).
7
Advertisement
Table of Contents
