Advertisement
2.3 Wire Labeling
GB
1. Disconnect and identify each wire.
2. Tape the wires to the wall to keep them from slipping through
the hole in the wall. If the hole in the wall is larger than
necessary, fill it in order to prevent hot or cold air to penetrate
the thermostat. In this manner, the thermostat will function
perfectly.
2.4
Choosing a Location
For a new installation, choose a mounting location:
1. About 5 feet (1.5 meter) above the floor in an area with good
air circulation.
2. Away from:
l. Drafts of dead air sports
ll. Air ducts
lll. Radiant heat from the sun or appliances
lV. Concealed pipes and chimneys
3. The best viewing angle is 12 o'clock direction.
-7-
2.5
Mounting
1. Mounting the thermostat onto the wall.
2. Remove completely the front housing of the
thermostat by using a screwdriver. (see picture)
3. Mark the holes' position and align the wire coming from the
wall in the hole beside the connectors. (see picture)
4. rill two holes and insert the plastic anchors carefully into the
holes until they are flush with the wall.
5. Fasten securely the thermostat to the wall with the two screws.
GB
-8-
Advertisement
