Table of Contents INTRODUCTION ..........................2 VELOCITY ADVANTAGE LAYOUT ....................4 PARTS LIST ............................5 VELOCITY ADVANTAGE ASSEMBLY INSTRUCTIONS ..............6 VELOCITY ADVANTAGE INSTALLATION INSTRUCTIONS ............. 10 BACKSTROKE LEDGE ADJUSTMENT ..................10 WARRANTY & PRODUCT REGISTRATION INFORMATION ............ 11 INTRODUCTION DANGER – FAILURE TO FOLLOW THESE WARNINGS, INSTRUCTIONS, AND THE OWNER’S MANUAL MAY RESULT IN SERIOUS INJURY OR DEATH.
PARTS LIST ITEM NO. QTY. PART NO. DESCRIPTION PARTS LIST 03-601 FRAME LEFT SIDE 03-602 FRAME RIGHT SIDE 03-603 FRAME TOP PARTS LIST 03-604 BACKSTROKE START HANDLE 03-603 FRAME SUPPORT PARTS LIST 03-606 FRAME BASE 26-100 BACKSTROKE START ASSEMBLY #10 X 2.5” FLAT HEAD SOCKET CAP 5-530 SCREW 10-24 x 1”...
VELOCITY ADVANTAGE ASSEMBLY INSTRUCTIONS Directions like left and right are based Disassemble backstroke start wedge. on a viewpoint facing the pool. 1.1) Unbox the backstroke start wedge. Ensure all of VELOCITY ADVANTAGE INSTALLATION INSTRUCTIONS its components are included. Unwind the spool so strap is not wrapped around. BACKSTROKE LEDGE ADJUSTMENT 1.2) Use a Phillips head screwdriver to remove a screw from each spool end.
Page 6
Assemble the Velocity Advantage frame 2.1) Place the left side (with the hole pattern) on a flat surface, number-side down. 2.2) Insert the base into the three holes as shown, flat surface towards the side piece. Refer to Figure 6 and Figure 7.
Page 7
2.5) Insert the backstroke handles into the pockets shown, rounded edges toward the outside of the block. Align the holes as shown in detail in Figure 10. 2.6) Insert the frame support into the frame top as shown, with the large number toward the back edge and the small number toward the short edge.
Page 8
Fasten the Velocity Advantage frame. 3.1) Rotate the advantage so its base is on the bottom. 3.2) Use an impact driver or drill and No. 2 square drive bit to fasten top plate to sides with 6 screws in the countersunk holes on the sides. (8). 3.3) Flip over starting block and fasten base to sides with 6 screws (8).
VELOCITY ADVANWARRANTY & PRODUCT REGISTRATION INFORMATIONVANTAGE INSTALLATION INSTRUCTIONS Set the backstroke ledge in the pool, looping the strap around and over the spool cap. Ensure VELOCITY ADVANTAGE INSTALLATION INSTRUCTIONS adjustment is initially set at 0 as shown in Figure 22 | Left Spool Cap Backstroke adjustment amount is Pins align with frame’s VELOCITY ADVANTAGE INSTALLATION INSTRUCTIONS...
WARRANTY & PRODUCT REGISTRATION INFORMATION WARRANTY & PRODUCT REGISTRATION INFORMATION For warranty information and details, please visit www.srsmith.com/en-us/customer-service/warranty- WARRANTY & PRODUCT REGISTRATION INFORMATIONFigure 20 | Backstroke Ledge information/. Register your S.R.Smith product at www.srsmith.com/en-us/customer-service/product- Adjustment WARRANTY & PRODUCT REGISTRATION INFORMATION registration Visit srsmith.com for information on the complete line of...