Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for S.R.Smith T7
Summary of Contents for S.R.Smith T7
- Page 1 DIVING SYSTEM ASSEMBLY & INSTALLATION INSTRUCTIONS ATTENTION! THESE INSTRUCTIONS MUST REMAIN WITH PLATFORM OWNER **PROFESSIONAL INSTALLATION RECOMMENDED** S.R.Smith, LLC 800.824.4387 srsmith.com Copyright ® 2020 S.R.Smith, LLC All rights reserved. BBK-T7 INSTALL | 0220...
- Page 2 Failure to properly install this product could result in a dangerous condition, including but not limited to electrical and or structural hazards. S.R.Smith. disclaims all liability arising from the installation and the user assumes all risk associated with the installation.
-
Page 3: Table Of Contents
Important Notices to the Installer ............................4 Minimum Diving Water Envelope Information ......................5 T7 Placement ....................................6 T7 Jig Info & Placement Tips ...............................7 Step 1: Install Water Feature (optional equipment) .....................8 Step 2: T7 Assembly ................................ 9-10 T7 Exploded View & Parts List ............................11 T7 Care &... -
Page 4: Safety First
WARNING SAFETY FIRST! This S.R.Smith diving board and stand shall be installed only by a professional swimming pool contractor or with the direct supervision of a licensed professional, engineer or architect. Diving boards may be installed only on residential in-ground swimming pools properly designed for their use. -
Page 5: Intended Use Instructions
Never install any S.R.Smith diving board on a variable Make sure that the diving board has been installed fulcrum dive stand. in compliance with the Assembly and Installation Don’t dive into a pool from anyplace not specifically... -
Page 6: Important Notices To The Installer
2011 Standard, and can result in serious injury or death. The installation of the T7 diving system is not complete until you, the installer have measured the pool to ensure it meets the S.R.Smith residential inground minimum pool specifications and the ANSI/APSP/ICC-5 2011 Standard for... -
Page 7: Minimum Diving Water Envelope Information
CROSS SECTIONAL DIMENSIONS AT POINT B MAX. DIVING BOARD LENGTH AT POINT A POINT A ROOM ABOVE DIVING POOL DIVING BOARD LENGTH SURFACES TYPE DIVING EQUIPMENT PROHIBITED 6’ DB / 6’ JB / 7’ T7 20” 2’-9” 5’-0” 4’-0” 7’-2.5” 7’-6” 6’-0” 3’-9” 2’-1.5” 12’... -
Page 8: T7 Placement
NOTE: WHEN COPING IS USED, DO NOT SET FRONT JIG BOLTS CLOSER THAN 3” FROM THE BACK EDGE OF THE COPING. TABLE 3 – PLACEMENT CHART ADDITIONALLY REFER TO: ANSI/APSP/ICC-5 2011 American National Standard for Residential In-ground Swimming Pools and to page 5 for S.R.Smith Residential In-ground Pool Minimum Specifications. DISTANCE FROM DISTANCE FROM NOMINAL MIN. -
Page 9: T7 Jig Info & Placement Tips
• Leave the protective caps on the bolts until the concrete has cured and base/stand is ready to be installed. • If installing a Board Fall with the T7 ensure that a 1/2” water stub-up is located per the diagram on page 6 and as shown in the above illustration. -
Page 10: Step 1: Install Water Feature (Optional Equipment)
T7 DIVING SYSTEM INSTALLATION INSTRUCTIONS IMPORTANT: The gel coat surface of the T7 Diving System is similar to a high quality marine finish; it is long lasting, strong and beautiful but will scratch if mishandled. Do not place unprotected parts on the ground. Do not slide or pull unprotected parts along any surface. Be careful unpacking parts and with tools during assembly. -
Page 11: Step 2: T7 Assembly
1. Lay board upside down on packaging being careful not to damage the gel coat surface. 2. Place T7-NSPRING over the 8 bolts on the board as shown in photo below.The single center drill hole in the spring center faces toward the pool. - Page 12 The assembly is now ready to set on the jig bolts. With 2 persons carefully set the assembly upright and onto the jig. If installing an Board Fall waterfall, tuck the excess hose underneath the base as it is set on the jig bolts. Using hardware kit T7-NBK attach the base to jig as shown in exploded view on page 11.
-
Page 13: T7 Exploded View & Parts List
3/8” NYLON INSERT LOCK NUT H-ANTI-SEIZE PACKET OF ANTI SEIZE LUBRICANT (NOT SHOWN) * not pictured NOTES: * Part #T7-NBASE comes WITH jig. The T7 diving board, base, and springs must be used together and cannot be used separately in any other configuration. srsmith.com... -
Page 14: T7 Care & Maintenance
T7 DIVING SYSTEM™ T7™ CARE & MAINTENANCE: Your T7 diving system requires periodic maintenance to keep it looking like new.* • Wash Monthly or more frequently, if needed. Be careful to keep cleaning material from entering the pool. • Wash with a mild soap such as hand dishwashing soap, avoid using strong cleaners or abrasives. Avoid strong alkaline (such as tri-sodium phosphate) or highly acidic cleaners. -
Page 15: Article 5 Extracted From Ansi/Apsp/Icc-5 2011
INSTALLATION MANUAL T7 DIVING SYSTEM™ SUPPORT INFORMATION: ARTICLE 5 – POOL DIMENSIONS AND TOLERANCES Extracted from ANSI/APSP/ICC-5 2011, American National Standard for Residential Inground Swimming Pools To obtain complete copies of the ANSI/APSP/ ICC-5 2011 Standard for Residential Inground Pools contact: The Association of Pool &... - Page 16 INSTALLATION MANUAL T7 DIVING SYSTEM™ SUPPORT INFORMATION: ARTICLE 5 – POOL DIMENSIONS AND TOLERANCES Extracted from ANSI/APSP/ICC-5 2011, American National Standard for Residential Inground Swimming Pools srsmith.com...
- Page 17 INSTALLATION MANUAL T7 DIVING SYSTEM™ SUPPORT INFORMATION: ARTICLE 5 – POOL DIMENSIONS AND TOLERANCES Extracted from ANSI/APSP/ICC-5 2011, American National Standard for Residential Inground Swimming Pools srsmith.com...
- Page 18 INSTALLATION MANUAL T7 DIVING SYSTEM™ SUPPORT INFORMATION: ARTICLE 5 – POOL DIMENSIONS AND TOLERANCES Extracted from ANSI/APSP/ICC-5 2011, American National Standard for Residential Inground Swimming Pools srsmith.com...
- Page 19 INSTALLATION MANUAL T7 DIVING SYSTEM™ srsmith.com...
- Page 20 INSTALLATION MANUAL T7 DIVING SYSTEM™ Copyright ® 2019 S.R.Smith, LLC All rights reserved. | srsmith.com...
Need help?
Do you have a question about the T7 and is the answer not in the manual?
Questions and answers