Download Print this page
Sealey LED035 Instructions

Sealey LED035 Instructions

Cordless 5 smd led + 3w cree rechargeable inspection penlight lithium-ion

Advertisement

Quick Links

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you
years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1.
GENERAL.
Ensure the penlight is correctly charged before initial use.
DO NOT turn the light on when it is being re-charged.
DO NOT shine directly into your, other person's or animal's eyes.
DO NOT allow children to use the penlight.
DO NOT use the penlight if you suspect that the battery or the penlight casing is damaged.
DO NOT immerse the penlight in water.
When not in use store the penlight in a safe, dry, childproof location.
1.2.
ELECTRICAL SAFETY.
USE ONLY THE SUPPLIED MAINS CHARGER PLUG FOR CONNECTING TO THE MAINS POWER SUPPLY.
WARNING! It is the user's responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An RCCB (Residual Current Circuit
Breaker) should be incorporated in the main distribution board. We also recommend that an RCD (Residual Current Device) is used with
all electrical products, particularly portable equipment which is plugged into an electrical supply not protected by an RCCB.
You must also read and understand the following instructions concerning electrical safety.
1.2.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.2.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance
and the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the charger plug, cable and connector for wear and damage to ensure items are safe before connecting to the mains power
supply. If worn or damaged DO NOT use.
Check cables are always protected against short circuit and overload.
Important: Check that the voltage marked on the charger plug is the same as the power supply to be used.
DO NOT pull the charger plug from the mains socket by the lead.
DO NOT use any other type of charger with this product.
DO NOT place the connector into any area of the spotlight except the correct jack inlet socket.
DO NOT try to take the charger plug apart.
DO NOT use the charger plug to charge or power any other electrical item.
DO NOT get the charger wet, or use in wet, damp conditions (for indoor use only).
WARNING! NEVER substitute a standard 13 Amp 3 pin plug, or any other type of plug, for the charger plug.
2. INTRODUCTION & SPECIFICATION
Small, compact design is ideal for keeping in pocket. Features 6 super bright LEDs. 5 SMDs (Surface Mount Devices) for use as an inspection
lamp and 1 ultra bright 3W CREE in top for use as a directional torch. Push on/off button on front of casing. Rechargeable Lithium-ion battery for
extra-long use. Supplied with USB lead and mains charger.
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LED035
Battery: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.7V 1.2Ah Li-ion
LED Quantity: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Lumen Output:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .150lm
Charging Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4hrs
Operating Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4hrs
Length:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 190mm
Fig.1
© Jack Sealey Limited
INSTRUCTIONS FOR:
CORDLESS 5 SMD LED + 3W CREE
RECHARGEABLE INSPECTION
PENLIGHT LITHIUM-ION
Model No: LED035
Original Language Version
LED035
Issue: 1 - 22/03/13

Advertisement

loading

Summary of Contents for Sealey LED035

  • Page 1 Model No: ........
  • Page 2 When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme.