Behringer ULTRADRIVE PRO DCX2496 Sync Manual page 8

"Software Update Service"
If you click on the "Software Update Service" button, you can browse
your hard disk to find the DCX2496 hardware update (or the PC remote
software) you downloaded from the BEHRINGER homepage (if a new
version is available).
"Synchronizing"/ "Synchronize"/ "Return"
Basically there are two ways to synchronize:
o "Direction: DCX2496 -> PC" assures that the PC has the same
settings as the selected DCX2496.
Note: You should do this at startup and every time you switch to another
DCX2496.
o "Direction: PC->DCX2496" is used only to store the current PC settings
to the DCX2496, or if you want to transmit the data edited offline to the
DCX2496.
o With the three "Data" clickable boxes, you can select what kind of data
should be transmitted from/to PC: only the current set or all presets from
internal bank or card bank.
o After you selected the desired direction and the desired data check
mark(s), click on "Synchronize" to start the synchronization.
7