Behringer ULTRADRIVE PRO DCX2496 Sync Manual page 7

"Recognized Devices" & "Device Information"
On the left window "Recognized Devices" you can select the particular
DCX2496 that you wish to edit. In this example, there is only one unit, called
"DCX2496," so you can't select another DCX2496.
On the right you will find the "Device Information" of the selected
"Recognized Device."
o Version" is provided only for your information (not editable)
and shows the current software version of the selected
DCX2496 hardware.
o Under "Name" you can change the name of the current device.
It's easier to work with names than numbers if you use two or
more devices. Just click on the current name, enter a new one
and press enter. Now the name of the "Recognized Device" (on
the left) will be updated too.
TIP: The newly entered name will be stored into the selected
hardware device. So don't be alarmed when you connect your
DCX to another computer with the remote software for the first
time and see "your name" shown.
o The "Device ID" should not be changed by the user!
Regardless of whether you use only one DCX2496 with your
PC or several DCX2496s, there is no need to change the
device ID (see examples below)!
However, if you change the ID while editing, you may lose data
in the PC editor and/or the DCX2496 itself, or your entire
system may freeze up.
Therefore, please refrain from changing the "Device ID" in the
PC software. If you want to change it, please select a new
device ID only at the DCX2496 hardware!
ATTENTION: For changing DCX2496s to edit, please select the
desired DCX ONLY via the left box "Recognized Devices"!
6