Philips Roku TV Quick Start Manual page 8

Notice
Trademarks are the property of Koninklijke Philips N.V. or their respective
owners. Funai Corporation reserves the right to change products at any
time without being obliged to adjust earlier supplies accordingly.
The material in document is believed adequate for the intended use of
the system. If the product or its individual modules or procedures are
used for purposes other than those specified herein, confirmation of their
validity and suitability must be obtained.
Funai Corporation warrants that the material itself does not infringe any
United States patents.
No further warranty is expressed or implied.
Funai Corporation cannot be held responsible neither for any errors in
the content of document nor for any problems as a result of the content
in document. Errors reported to Funai Corporation will be adapted and
published on the Funai Corporation support website as soon as possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although it has
effective pixels of 99.999 % or more, black dots or bright points of light
(red, green or blue) may appear constantly on the screen. This is a
structural property of the display (within common industry standards) and
is not a malfunction.
Warranty
No components are user serviceable. Do not open or remove covers to
the inside of the product. Repairs may only be done by service centers
and official repair shops. Failure to do so shall void any warranty, stated
or implied.
Any operation expressly prohibited in document, any adjustments or
assembly procedures not recommended or authorized in document shall
void the warranty.
Federal communications commission notice
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio or television technician for
help.
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1)This device may not cause harmful
interference, and (2)This device must accept interference received,
including interference that may cause undesired operation.
Declaration of conformity
Trade name: PHILIPS
Responsible party: Funai Corporation, Inc.
Model:
32PFL4764/F7 A, 32PFL4664/F7 A, 24PFL4664/F7
Address: 12489 Lakeland Road, Santa Fe Springs, CA 90670, USA
Telephone number : 1 866 309 5962
Modifications
This apparatus may generate or use radio frequency energy. Changes or
modifications to this apparatus may cause harmful interference.
Any modifications to the apparatus must be approved by Funai
Corporation.
The user could lose the authority to operate this apparatus if an
unauthorized change or modification is made.
Cables
Connections to this device must be made with shielded cables with
metallic RFI / EMI connector hoods to maintain compliance with FCC rules
and regulations.
FCC statutory notice for wireless LAN adapter.
FCC caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
FCC RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment should be installed and operated keeping the
radiator at least 20 cm or more away from your body.
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the passed
down through the MAC, through the digital and analog baseband, and
finally to the RF chip. Several special packets are initiated by the MAC.
These are the only ways the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of the packet. Therefore,
the transmitter will be on only while one of the aforementioned
packets is being transmitted. In other words, this device automatically
discontinue transmission in case of either absence of information to
transmit or operational failure.
Positioning the TV
•
Large screen TVs are heavy. 2 people are required to
carry and handle a large screen TV.
•
Make sure to hold the upper and bottom frames of the
unit firmly as illustrated.
•
Install the unit in a horizontal and stable position.
•
Do not install the unit in direct sunlight or in a place
subject to dust or strong vibration.
•
Depending on the environment, the temperature of this unit may
increase slightly. This is not a malfunction.
•
When installing this unit in a temperate environment, avoid a place with
rapid temperature changes.
•
This unit should not be used in a tropical environment as it has not been
evaluated under such conditions.
•
No objects should be placed directly on or under this unit, especially
lighted candles or other flaming objects.
•
Depending on your external devices, noise or disturbance of the picture
and / or sound may be generated if the unit is placed too close to them.
In this case, please ensure enough space between the external devices
and the unit.
•
Do not insert the AC power cord into the power socket outlet before all
the connections are made.
•
Ensure that you always have easy access to the AC power cord and
outlet to disconnect the TV from the AC outlet.
•
Before you move the TV, disconnect attached cables to prevent damage
to connectors, especially the TV tuner.
•
Be sure to unplug the AC power plug from the AC outlet before moving
or carrying the unit.
•
When moving the TV and then setting it down, please be careful not to
pinch the AC power cord under the unit.
Regulatory notices
WARNING: To prevent injury, this apparatus must be securely attached to
the furniture / wall in accordance with the instructions.
Tipping, shaking or rocking the unit may cause injury / death.
WARNING: Never place a TV in an unstable location. A TV may fall,
causing serious personal injury or death. Many injuries,
particularly to children, can be avoided by taking simple
precautions such as:
– Using cabinets or stands recommended by the manufacturer
of the TV.
– Only using furniture that can safely support the TV.
– Ensuring the TV is not overhanging the edge of the
supporting furniture.
– Not placing the TV on tall furniture (for example, cupboards
or bookcases) without anchoring both the furniture and the
TV to a suitable support.
– Not placing the TV on cloth or other materials that may be
located between the TV and supporting furniture.
– Educating the children about the dangers of climbing on
furniture to reach the TV or its controls.
If your existing TV is being retained and relocated, the same
considerations as above should be applied.
Do not place the unit on the furniture that is capable of being tilted by a
child and an adult leaning, pulling, standing or climbing on it. A falling unit
can cause serious injury or even death. In order to avoid interruption of
ventilation, this unit should not be placed in built-in equipment such as a
book cabinet, rack, etc., and the vents of this unit should not be covered
with anything such as a tablecloth, curtain, newspaper, etc. Make sure
that there is enough ventilation space (4 inches / 10 cm or more) around
this unit.
Press B to turn the unit on and go into standby mode. To completely turn
off the unit, you must unplug the AC power plug from the AC power outlet.
Disconnect the AC power plug to shut the unit off when trouble is found or
En
not in use. The AC plug shall remain readily available.
AC power plug
Never use a gas duster on this TV.
The gas trapped inside of this unit may cause ignition and explosion.