Advertisement
HOW TO ENTER A TEMPERATURE OFFSET
This heater allows the user to manually enter a temperature offset for the temperature probe. This is useful
when the heater is located in a particularly exposed or particularly sheltered location, to correct the
temperature reading relative to another relevant location within the same space.
1. Press the
key.
2. The " ► " indicator will position itself in front of "Programs". Press
indicator in front of "Configuration".
3. Press the
key.
4. The " ► " indicator will position itself in front of "Time". Press the
"Offset".
5. Press the
key.
6. The text "Offset: 0ºC" will be displayed. Press
(Note: this offset can be positive or negative, and is added to the temperature value obtained by
the probe. If you select +5ºC, a probe reading of 15ºC will be displayed as 20ºC, conversely, if you
select -5ºC, a probe reading of 15ºC will be displayed as 10ºC).
7. Once you are satisfied that the displayed value is the one you wish to apply, press the
a few seconds the corrected temperature will be displayed and the heater will use it to turn on or
off.
HOW TO RESET A HEATER:
NOTE: If you reset the EG heater, all of the customised programmes that you may have stored in the
memory will be deleted, as well as time and day of the week settings. Any programs that have been
configured by the user will be replaced by a standard program.
1. Press the
key.
2. Press the
key once, Which will make the " ► " indicator position itself in front of "Config".
3. Press the
key.
4. Press the
key three times, which will make the " ► " indicator position itself in front of "Reset".
5. Press the
key.
6. The text "Sure: No" will be displayed. Press
7. Press
. The Heater will now be reset.
and
keys to display the offset you wish to apply
or
to change the text to "Sure: Yes",
key to position the " ► "
key twice to position it in front of
key. After
Advertisement
