Farho ECO GREEN Instructions

INSTRUCTIONS FARHO© ECO GREEN
The ECG model is the latest product in FARHO© range. This heater combines high technology
performance with easy management. FARHO© ECG models can be programmed in up to six
independent operating periods for each day of the week and it can also be controlled from the front
panel.
This heater incorporates a "open window detection" function, which can be enabled from the menus.
When operating in this mode, the heater will pause operation (i.e. stop consuming) whenever it detects a
drop of 2ºC or more in less than 5 minutes. This function only applies when the heater is consuming.
The ECG-LST has the same characteristics as the ECG and therefore it is operated just like the ECG,
except for one thing: the maximum surface temperature is limited to 40º Celsius in order to fulfil a
European Regulation that requires limited surface temperature on heaters that are to be installed in
schools, nurseries and hospitals in order to avoid possible accidents with children.
DESCRIPTION OF THE KEYPAD AND DISPLAY:
The FARHO© Eco Green model is controlled by means of intuitive menus, thus greatly facilitating its use.
In order to access the menu, simply press the button labeled
buttons (+) and
on the screen. To select a menu item or to perform an action, simply press
Increase temperature and scroll up on menus
Decrease temperature and scroll down on menus
Enter menu / Accept / Back (long press)
HOW TO SET THE CLOCK:
1. Press the key.
2. Press the key ONCE, which will make the " ► " indicator position itself in front of "Configuration"
3. Press the key.
4. The " ► " indicator will now be positioned in front of "Time". Press the
5. Press the and
6. Press the key.
7. Press the and
8. Press the key.
9. Press the and
10. Press the key.
CHANGE TEMPERATURE:
To raise or lower the room temperature simply press buttons
displays the desired temperature level. The Farho heater will automatically adjust the heat emission
efficiently until reaching the temperature level set.
HOW TO KNOW IF THE HEATER IS CONSUMING OR NOT:
If the heater is consuming, the pre-set temperature indicator on the display will flicker. If it
is not flickering, the heater is in the idle mode.
(-). To go back to the previous menu, just press and hold
keys to enter the correct day of the week.
keys to enter the correct hour setting.
keys to enter the correct minute setting.
(OK) and scroll through it by pressing the
until "Back" is displayed
for a short period.
key again.
or until the temperature indicator