Advertisement
6. Upon having the " ► " indicator positioned in front of a day of the week which program you wish
to edit, you can select it by pressing
indicating this day is selected for editing. You can select multiple days for which you want the
same program to apply.
7. Once you are satisfied that you have selected all the days for which you want the same program
to apply and no others, you can scroll back to the start of the list, by pressing
indicator is positioned in front of
8. Press
to go into programming mode.
9. Press
once to set the start time of the first slot to "00:00" (Note: it is strongly advised that all
programs start at "00:00" and end at "00:00").
10. Press
twice.
11. Press
and
12. Press
and
13. Press
and
14. Repeat steps 10 – 13 until you reach "00:00" as an ending time for your programming block
(Reminder: maximum 6 programming blocks available).
15. If you have programmed less than 6 blocks in total, you need to press
displayed as a starting time for the next block, and then press
editor to close and the program to be stored. If you press and hold
no changes will be stored.
HOW TO ENABLE OR DISABLE OPEN WINDOW DETECTION FUNCTION:
TO ENABLE OPEN WINDOW DETECTION:
1. Press the
key. The " ► " indicator will position itself in front of "Programs".
2. Press the
key once to position the " ► " indicator in front of "Configuration".
3. Press the
key. The " ► " indicator will position itself in front of "Time".
4. Press the
key once to position the " ► " indicator in front of "Window sensor".
5. Press the
key.
6. The text "Wind: Off" will be displayed. Press
7. Press
. The Open Window Detection function will now be enabled.
TO DISABLE OPEN WINDOW DETECTION:
1. Press the
key. The " ► " indicator will position itself in front of "Programs".
2. Press the
key once to position the " ► " indicator in front of "Configuration".
3. Press the
key. The " ► " indicator will position itself in front of "Time".
4. Press the
key once to position the " ► " indicator in front of "Window sensor".
5. Press the
key.
6. The text "Wind: On" will be displayed. Press
7. Press
. The Open Window Detection function will now be disabled.
to set the desired ending hour for the first program slot, and then press
to set the desired ending minute for the first program slot, and then press
to set the desired temperature for the first programming block, and then press
. This will cause a cross to appear on within the square,
.
or
to change the text to "Wind: On".
or
to change the text to "Wind: Off".
until the " ► "
and
keys until "--:--" is
. This will cause the programs
to exit the programs editor,
.
.
.
Advertisement
