Control Horn And Servo Arm Settings - Horizon Fitness hobbyzone Apprentice S2 Instruction Manual

Wing Installation
1. Connect the aileron servo connectors to the included Y-harness (A) in the
fuselage. The left and right servos can be connected to either side of the
Y-harness. Ensure the Y-harness is connected to port 2 of the receiver.
2. Install the wing on the fuselage.
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
3. Install 6 rubber bands (B) on the front and back rods to complete the
installation.
Disassemble in reverse order.
IMPORTANT: Correct operation of the SAFE system requires connection of
both ailerons to the included Y-harness and port 2 of the receiver.

Control Horn and Servo Arm Settings

NOTICE: Moving a linkage to another position may block the servo arm or
affect SAFE technology functionality.
The Illustration shows the factory hole settings in servo arms and control horns.
1
A
OR
2
B
Elevator Ailerons
9
EN
Rudder
Nose Gear
Rudder
Apprentice S 2 1.2m
®