Table of Contents
Advertisement
Figure 100. Installing the R3 paddle card
Next steps
1. Insert the paddle card slimline cable into the cable access latch on cooling fan cage and also through the air shroud notch.
2. If removed,
install the rear mounting front PERC
3. Follow the procedure listed in
Replacing the GPU bracket
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If installing a new GPU card, unpack it and prepare the card for installation.
NOTE:
For instructions, see the documentation accompanying the card.
4. New GPU cards are shipped with standard bracket, replace it with a custom bracket before installing.
NOTE:
Based on the GPU card, use the appropriate custom bracket.
Steps
1. Using Torx #T15 screwdriver loosen the torx screws and remove the standard bracket from the GPU card.
104
Installing and removing system components
module.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
