Inserting / Replacing Batteries; Positioning The Scales; Adjusting The Unit Of Weight; Operation - Silvercrest 317306 Operation And Safety Notes

Set-up / Operation / Troubleshooting

Inserting / Replacing Batteries

Note: the batteries must be inserted prior to initial
use. First, remove the insulating strips from the battery
compartment .
3
Note: if the scales do not respond, remove and
reinsert the batteries.
Open the battery compartment cover
Insert the three included batteries (with the cor-
rect polarity) in the battery compartment
Please note the markings inside the battery
compartment
.
3
Close the battery compartment cover
you hear it click into place.

Positioning the scales

Place the scales on a stable, level
surface. A solid floor covering is re-
quired in order to achieve correct
weight measurements.

Adjusting the unit of weight

The factory default setting for the scales as supplied
is „kg". If you wish to switch to „lb" or „st", press
the UNIT button on the back of the scales as
4
many times as required.

Operation

Tip: if possible, always weigh yourself at the same
time of day (preferably in the morning) after visiting
the toilet, with an empty stomach and without clothing
to ensure that your results are comparable.
Note: if the location or the batteries are changed,
the scales must be re-calibrated. To re-calibrate, do
the following: step onto the scales quickly. Step off
the platform . The scales will be calibrated auto-
1
matically. Wait until the scales switch off automati-
cally. The scales are now calibrated and you can
weigh yourself.
18 GB/IE

Measurements

Step onto the scales barefoot and be sure to
stand still on the platform
distributed equally between both legs.
Note: if possible, stand on the same area of
the platform
. Moving during the weighing process can lead
3
to discrepancies in the results.
. The scales will start to measure immediately.
3
The weight display in the LED display
blink before showing the result.
until Step off the platform
3
value in the LED display
about 10 seconds. Until then the weight meas-
urement remains visible.

Turning off the scales

The scales feature an automatic shut-off function
and will automatically switch off after displaying
the results.

Troubleshooting

= Error / Display
= Cause
= Solution
= The LED display
= The batteries in the scales are dead.
= Replace the batteries.
= The LED display
= The maximum load capacity of 180 kg /
396 lb / 28 st has been exceeded.
= Do not exceed 180 kg / 396 lb / 28 st.
= "Err" or incorrect weight is displayed.
= The surface is not level or stable.
= Place the scales on a level, stable surface.
= You are not standing still.
= Stand as still as possible.
with the weight
1
each time and do not move.
1
. The measurement
1
will disappear after
2
reads "Lo".
2
reads "Err".
2
will
2