Working In Manual Mode - AEG CLR215 Original Instructions Manual

WORKING IN MANUAL MODE

In manual mode the cross lasers self-leveling mechanism is disabled and the laser lines can
be set at any slope required.
1
Place the cross laser on a solid
fl at vibration free surface or on a
tripod.
2
Long press the I/O button (do
not slide the locking switch!).
The operation LED indicator will
light up.
3
Same as in the self-leveling
mode, the cross laser will
generate 2 laser beams, but the
laser beams are interrupted
every 3 seconds.
3 sec. 3 sec. 3 sec.
ENGLISH
4
CLR215 only:
Choose the beams that
you want to work with
by pushing operation
push button
5
Tilt the laser using a tripod and adjust
to the desired angle and height.
6
For CLR215, long press the I/O button to
turn off the manual mode.
For CLG220, short press the I/O button to
turn off the manual mode.
It is possible to switch directly to the
self-leveling mode by sliding the locking
switch to ON position.
7