Adjusting Level Gain; Warranty - Bazooka EL10A Installation Manual

Bazooka el10a: install guide
Table of Contents

Advertisement

channels is wired out of phase with the other. To correct this situation, simply
reverse the connections on one of the two input channels. When the wiring
is in correct electrical phase, the level of bass output will be greatest when
the balance control of the radio is set to the center position.
LOW-LEVEL INPUT:
If your source unit only has low-level RCA phono jack output, use only the
low-level inputs of the Amplified Bazooka.
Connect the low-level RCA phono jack inputs of the Amplified Bazooka to the
source with a shielded RCA patch cord. To avoid possible noise problems, be sure
to run the patch cord away from all power wires and factory wire harnesses.
When using the low-level inputs DO NOT make any connections to the
Green and Gray high-level input wires of the Amplified Bazooka and make
sure these wires are insulated to avoid the possibility of a short circuit.
All SAS
®
EL Series
the date of purchase. Terms and conditions of the warranty are as stated on
the warranty card included in the box with the product. SAS recommends
that you use only authorized BAZOOKA
Improper or incorrectly performed installation voids this warranty.
®
BAZOOKA
subwoofer speaker systems exclusively incorporate the
revolutionary Bass Tubes
®
only from SAS.
, SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc.
SIGNAL CONNECTIONS CONT.

WARRANTY

products are covered under warranty for one full year from
BASS TUBES
®
patented subwoofer enclosure design available
PAT. NO. 4,567,959 PAT NO. 5,097,513
dealers to install this product.
®
ENCLOSURE
®
14

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

El6aEl8aEl5a

Table of Contents