For future reference please record the following information which can be found on the Rating Plate and the date of purchase which can be found in the invoice: Model Number Serial Number Date of Purchase ……………………. Supplier ……………………. ……………………. …………………….
Installation Instructions. The use for any other purpose or in any other environment without the express agreement of Baumatic Ltd, would invalidate any warranty or liability claim. Your new appliance is guaranteed against electrical or mechanical defects subject to certain exclusions noted in Baumatic Conditions of Guarantee.
Page 8
CE Marking – 93/68 Low Voltage – 73/23 EMC – 89/336 Safety Standards – EN 60 335-1, EN 60 335 – 2 – 6. As Baumatic have a policy of continued product improvement, the right is reserved to adjust and make any modifications deemed necessary without notification.
Baumatic advise that this appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely.
Page 10
For electrical installations, NICEIC registration is recommended. Baumatic Ltd declines any responsibility for injury or damage to persons or property as a result of improper use or installation of this appliance.
Do not remove the rating plate from the appliance, as this will invalidate the guarantee. Immediately fill in the guarantee card and return to Baumatic in order to register your new purchase. FIRST USE After you have installed your oven it is recommended to put the oven elements on for approximately 30 minutes at 200 degrees C.
COOLING FAN The cooling fan comes on after a short period of time when the grill or any of the oven functions are selected and will remain on while the oven is in use. DO NOT turn the oven off at the power point until the cooling fan has switched off as this may cause damage to surrounding areas.
The oven light remains on whilst the oven is in use. CONVECTION MODE This provides traditional cooking with heat from the top and bottom elements. TOP ELEMENT MODE (AS11-A, B230CH-A). This is for gentle cooking, browning or keeping cooked dishes warm. LOWER ELEMENT MODE (AS11-A, B230CH-A).
This provides even heating with the fan and allows different dishes to be cooked at the same time on different levels. FAN ASSIST MODE 1 (all models except AS11-A, B230CH-A ) This provides semi-convection heating with lower element for delicate dishes. FAN ASSIST MODE 2 This provides convection heating with upper and lower elements for even cooking.
• Do not wrap items in aluminium foil and place under the grill – the high reflectivity of the foil can damage the grill element. HELPFUL HINTS • Before cooking, check that any unused accessories are removed from the oven. •...
Page 16
ELECTRONIC PROGRAMMER/ TEMPERATURE DISPLAY The electronic programmer is a device, which groups together the following functions: - 24 hours clock with illuminated display - Timer (up to 23 hours and 59 min.) - Program for automatic beginning and end of cooking - Program for semi-automatic cooking (either start or finish only) - Displaying the required...
Page 17
Manual cooking taking place Automatic cooking taking place Timer in operation NOTE: After having selected the operation, a period of time will pass (about 3-4 seconds) before confirmation, during which the data may be modifies. Digital clock (THE CLOCK MUST BE SET BEFORE OVEN WILL OPERATE) Clock numbers show hours (0-24) and minutes.
Page 18
1) Automatic cooking (start and end) Set temperature and cooking program required by using the thermostat and the selector knobs. Set the length of cooking time by pushing the Set the end of cooking time by pushing the After this setting the symbol «A» will light. An example: cooking lasts 45 minutes and is expected to stop at 14.00.
Page 19
Timer = buzzer The timer program consists only of a buzzer, which may be set for a maximum period of 23 hours and 59 min. To set the timer, push the button and, at the same time, + or - until you read the desired time on the display.
Scratches caused by use of cleaning agents not recommended by BAUMATIC LTD will invalidate the guarantee. When cleaning the oven, the shelves and side racks can be removed. Remove shelves by pulling forward. The side racks are held in position by 2 hooks at the top and a securing nut at the bottom.
REMOVING THE OVEN DOOR To facilitate cleaning inside the oven, the door can be removed as follows: Hinges “A” are provided with two movable bolts “B”. When bolt “B” is raised, the hinge is released from its housing. Having done this, the door must be lifted upwards and removed, sliding it towards the outside;...
PRE-COMMISSIONING THE APPLIANCE When unpacked, check that the following parts are included with the appliance: • Baumatic Instruction and Installation Book • Screws and plugs for fixing appliance into housing. • Grill pan, grill pan handle and grill pan trivet.
Page 23
3. All ovens with which this instruction book is provided may be installed without the need for any additional ventilation cutouts. 4. Ensure that the oven has been securely fixed into the housing. The fixing of the oven in the cabinet is made by 4 screws “A” that on the corner of the oven doorframe.
Page 24
Fig. 3: Installation distances for 60cm wide single electric ovens (Shape of top casing may vary)
Page 25
Fig. 4: Ventilation and cut-out requirements for installation of a Single electric oven into a standard kitchen unit. Fig. 5: Ventilation and cut-out requirements for installation of a Single electric oven into a tall housing unit.
ELECTRICAL CONNECTION Before connecting the appliance, make sure the supply voltage marked on the Rating Plate corresponds with the mains supply voltage. WARNING – THIS APPLIANCE MUST BE EARTHED This appliance should be wired into a 13A double pole switched fused spur outlet having 3mm contact separation and placed in an easily accessible position adjacent to the appliance.
Before carrying out any maintenance, disconnect the appliance from the electricity supply. During the guarantee period, in case of need all service interventions should be referred back to the Baumatic Ltd Service department. Please note that intervention or repair by any unauthorised personnel will invalidate such guarantee.
If the liners are allowed to become black and shiny, they must be replaced by new items. Remove all internal accessories to facilitate replacement of the liners. Replacement liners may be purchased directly from the Baumatic Spares Department (details as per back cover). Please quote product-type references B600 and/or your appliance’s serial...
Should a Baumatic Engineer be called and finds that the fault and solution is list in this guide then you will be charged for the call whether or not the appliance is within the guarantee period.
Page 30
Food is not cooking evenly. Check that the oven has been installed correctly and is level. Check that the correct temperatures and shelf positions are being used. The oven light fails. Refer to page 24 replacing the oven light bulb.
525mm COOLING FAN A tangential cooling fan is fitted on the following models: AS8-A, AS11-A, B190-A, B200-A, B201-A, B205-A, B209-A, B230CH-A, B495-A, B497-A, B550-A ELECTRICAL DETAILS Rated Voltage: Supply Connection: 13A (double pole switched fused outlet with 3mm contact gap)
Baumatic appliance. * In addition, your appliance is covered by a 5 year parts warranty. Baumatic Ltd will provide free of charge the parts required to repair the appliance, only if they are fitted by a Baumatic engineer, for any defect that arises due to faulty materials or workmanship within a period of 5 years from the original purchase date.
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment.
Page 36
Baumatic ® w w w . b a u m a t i c . c o m...
Need help?
Do you have a question about the B230CH-A and is the answer not in the manual?
Questions and answers