Infinity Boss.three 700c Manual page 2

Close
Rails
Seat post
Seat clamp
Quick release
NOTE: Comfort Series bicycles may be equipped with a stem that has an adjustable angle.
bolt. Failure to do this may cause loss of steering control.
If
to o
in
front wheel. Try turning the handlebar. If you can turn it without turning
the front wheel, the stem is too loose. Re-align the handlebar with the
fron
FRONT WHEEL
Quick Release Wheels
1. Locate the quick release skewer from the small parts carton of your bicycle. Some
bicycle so tha
2. Unscrew the lock nut from the quick release skewer, remove outer spring and slide
th
bike (the side opposite the chain).
3. Install spring and then start to thread the lock nut back onto the skewer, but do not
en too far.
4. Slide the wheel into the fork wheel slots and be sure that the wheel is centered.
5. Inspect the handle, not
the lock nut, st
with the fork.
6.
try again.
7.
NOT a
closing, the lock nut (opposit
Next go back and check that the handlebars are perpendicular to the front wheel,
go back to handlebar assembly and re-adjust if needed.
All quick release levers should be inspected before every ride to be sure
they are fully closed and secure. Failure to properly close a quick release
lev
Make sure the wheel is properly seated and the quick release is
properly closed.
SADDLE ASSEMBLY
The seat pos
be seen. The quick release mechanism mus
bicycle control.
The saddle assembly should be adjusted with the saddle centered on the rails and
level. Locate the saddle assembly and insert into the frame. It is recommended to add
some grease to all threads and binders on a bicycle, especially on the outside of the seat
po
Bolted Seat Clamp
If your bicy
the clamp so that the saddle ma
th
mark on the seat post. Riding a bicycle with the seat post above this line is dangerous
and can cause injury to the rider or damage to the bicycle or create an unstable riding
t.
Quick Release Seat Clamp
If your bicycle has a seat clamp with a quick release, adjust seat to desired height, and
up or down. If the saddle mo
th
mark on the seat post. Riding a bicycle with the seat post above this line is dangerous
and can cause injury to the rider or damage to the bicycle or create an unstable riding
t.
www.infinitycycleworks.com
copyright 2017 - Infinity Cycle Works Ltd.
, these stems will require angling the stem to the
ailure to do this may cause loss of