Polygroup ILLUMINATIONS COLOR BLAST C35 Owner's Manual

ILLUMINATIONS
C35 FACETED PATHWAY MARKER LED LIGHTS
READ, AND KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
FAILURE TO FOLLOW THESE WARNINGS AND INSTRUCTIONS CAN RESULT IN SERIOUS INJURY OR DEATH TO USERS, ESPECIALLY CHILDREN.

IMPORTANT SAFETY INSTRUCTIONS

When using electrical products, basic precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
1.
2. Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When used outdoors,
this product must be connected to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not provided,
contact a qualified electrician for proper installation.
3. This seasonal use product is not intended for permanent installation or use.
4. Do not mount or place near gas or electric heaters, fireplace, candles or other similar source of heat.
5. Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
6. Do not let lamps rest on the supply cord or on any wire.
7. Unplug the product when leaving the house, or when retiring for the night, or if left unattended.
8. This is an electric product - not a toy! To avoid risk of fire, burns, personal injury and electric shock, it should not be
played or placed where small children can reach it.
9. Do not use this product for other than its intended use.
10. Do not hang ornaments or other objects from cord, wire, or light string.
11. Do not close doors or windows on the product or extension cords as this may damage the wire insulation.
12. Do not cover the product with cloth, paper or any materials not part of the product when in use.
13. This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning
use of the product in a safe way and understand the hazards involved. Children shall not play with the product.
Cleaning and user maintenance shall not be made by children without supervision.
14. The supply cord, adaptor, plugs and/or connectors cannot be replaced or modified. If either is damaged, the product
should be scrapped.
15. Strobe lights have been known to trigger seizures in people with photosensitive epilepsy.
16. Read, and follow all instructions that are on the product or provided with the product.
SAVE THESE INSTRUCTIONS.
17.
CAUTION:
1. To reduce the risk of fire or electric shock:
• Do not install on trees having needles, leaves or branches covering of metal or materials which look like metal;
• Do not mount or support cords or cables in a manner that can cut or damage wire insulation;
• Do not attempt to replace lamps or modify power cord;
• Use only the adaptor provided with this product, and
• This product does not contain lamp shunts, which allow the product to operate if one lamp burns out.
2. Make sure connectors are fully inserted and any connector rings are twisted until completely secured such that the
rings can no longer be turned and the two portions of the connectors are completely assembled.
3. The lighting string is rated 2.9 Watts (0.58 Amps). Do not overload. Connect other COLOR BLAST
lights (Type B) end-to-end up to a maximum of 10 Watts (2.0 Amps) total. To avoid the risk of fire or personal injury,
do not exceed the maximum allowable electrical load.
C35 Faceted Pathway Marker LED Lights
Rated Wattage: 2.9W (0.58A), Total Wattage: 4 Watts
Maximum Wattage Capacity: 10W (2.0A)
AC Adaptor
Input: 120V/60Hz, 0.16A
Output: DC 5V, 2A
Unit 606, 6/F, Fairmont House, 8 Cotton Tree Drive, Central, Hong Kong
COLOR BLAST
REMOTE CONTROLLED LED LIGHTS
Warning
DISTRIBUTED BY: Polygroup
OWNER'S MANUAL
TM
Trading Limited
®
TM
remote controlled LED
™
1