Baumatic BF344 Instruction Manual page 22

REVERSING THE DOOR OPENING (swing of the door):
Look at the middle section where the middle hinge
16)
will go and gently remove the two filler caps. Note that
the holes contain insulation foam which can be bored
into easily.
Take the top door's bottom hinge socket from the
17)
former opening side of the door. Replace it in the hinge
hole on the other side.
Invert the middle hinge and carefully latch the top
18)
pin into the bottom socket of the top door.
Now attach the middle hinge assembly. Ensure that
19)
the top door can open and close properly and levelly
before you move to the next step.
Reverse the position of the hinge sockets at the
21)
top and the bottom of the bottom door (as you had
done with the top door).
Remount the lower door. If you can, have
22)
someone else hold it so it goes back on straight and
ensure that the top pin fits into its socket properly.
Reattach the bottom hinge, making sure that the
23)
pin fits into its socket properly and it has a washer.
Ensure all hole covering caps are replaced.
24)
NOTE – TEST THE OPENING AND CLOSE OF BOTH DOORS
21
Reassemble
20)
the hinge 'C' and
the support 'L' on
the left hand side.
The hinge cover 'H'
must be remounted
at the end of the
installation.