Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in
a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.
Salamander Designs Ltd.
•
800-535-5659
BEFORE YOU BEGIN:
!
!
• Unpack all parts and read instructions carefully before beginning.
• Shelf pegs and door hinges must slide into the channels of the post in the correct order.
TM
They cannot be removed individually without disassembly.
1
Connect Posts to Bottom Shelf
A
.
Square Post
Square the post to the bottom shelf.
B
.
Connect Post
Screw foot with metal washer through bottom
shelf and into the end of each extruded post.
Hand tighten fully and use wrench to tighten
nut onto underside of shelf.
WARNING: Tighten by screwing the leveler foot NOT the post.
Summary of Contents for Salamander Designs SYNERGY SYSTEM SLC20
Page 1
Limited Warranty Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner.
Page 2
Add Shelf Pegs Attach Rear Panels Insert Hardware Pegs for Shelves Combine the 1” threaded studs with flat nuts. Insert one shelf peg down each post. NOTE: There are two varieties of shelf pegs Slide 2 sets of hardware down the two outside (A and B).
Placing Shelves If assembling model SLC20, skip to step C. 8" 6" " Adjustable Shelves Fine Tuning Bracket Triple-Width Shelf Place shelves from the bottom up. Angle Use the bubble level to precisely adjust Place shelf on center posts and Loosely install brackets down outer posts.
Install Spanner Top Assembly Secure Top Disassemble cross dowel using the hex key as shown. Secure top with the connector bolts. Place the plastic plugs in the front center holes. 400-080 Install the cross dowels into both ends of the spanner as shown.