Cleaning And Maintenance - Swann activair SAC16810N Manual

Table of Contents

Advertisement

A. MAINTENANCE OF THE APPLIANCE:
Before any maintenance and cleaning operation, it is ESSENTIAL to disconnect
the power cable from the mains for safety reasons.
Do not use chemicals or detergents for cleaning or maintenance of the appli-
ance. This could damage your device.
The outside of the air conditioner can be cleaned with a slightly damp cloth.
B. DRAIN THE APPLIANCE:
To empty your device, put a container under the cap to collect water.
Remove the cap to let the water out.
Once all the water has drained, replace the plug.
C. MAINTENANCE OF THE AIR FILTER:
For best efficiency, the air filter should be cleaned after 100 hours of use.
Turn off the device and unplug the power cable
Unscrew the middle screw and remove the air filter.
Clean and reinstall the air filter. If the filter is very dirty, wash the filter in warm,
soapy water, then rinse and dry before putting it back in place.
Tighten the middle screw.
Note : When using the air conditioner in an extremely dusty environment, clean
the air filter every 2 weeks.
SAC16810N_IM.indd 13

CLEANING AND MAINTENANCE

Rubber stopper
Grille
Filter
13
27/03/2020 11:11

Advertisement

Table of Contents
loading

Table of Contents