Initial Scanner Start-Up - Siemens CLSC3000 Installation Manual

CLSC3000
11

Initial Scanner Start-Up

Installation Manual, CLSC004enI3c
© Siemens AG 2010 / Date of issue: 2010-05-19
Note!
Once the application kit has been installed, there are two ways to
access the IDH:
Direct work at the IDH. This requires direct connection of a mouse,
−
keyboard and monitor to the IDH.
Remote access via the network from another network computer or from
−
the operating station. This requires availability of the user interface
WebUI_CCS. Refer to the document "Web User Interface Centralized
Computer System WebUI_CCS, SW User Manual" for details.
Turn on the compressed air supply for the CLSC at the manually
operated valve located on the transport plate behind the CLSC (for
details refer to the documentation "Colour Letter Scanner CLSC3000,
Maintenance Instructions").
Switch on the power supply for the scanner in the respective machine
module. For details refer to the respective machine documentation or
drawing.
Note!
The CLSC carries out an internal self-test after power-up. The test
takes about 20 to 30 seconds. The red LED on the scanner is on during
that time.
The green and yellow LEDs should be on. For details refer to the
documentation "Colour Letter Scanner CLSC3000, Adjustments and
Repair", chapter "Error Handling".
Switch on the power supply for the computer cabinet resp. of the UPS.
Initial Scanner Start-Up
11-1