Table of Contents
Advertisement
Photo Taking
Ñ
Single Shot Mode
To take a single photo, set the photo mode setting in the camera configuration to
be single shot mode. Tap the Camera Button to take a photo. The green LED will
flash and you will hear a shutter sound.
Ñ
Burst Shot Mode
Burst shot takes 8 photos. To take multiple photos, set the photo mode setting in
the camera configuration to be burst shot mode. Tap the Camera Button to take
multiple photos. The green LED will flash and you will hear shutter sounds.
NOTE
• If you are recording in 2160p/30fps of video resolution, you cannot take a photo.
• Burst shots cannot be taken while recording video. Even if the burst shot mode is set,
only a single shot is taken when you tap the camera button while recording video.
• The camera resolution is fixed to 12MP. However, when you take a photo during video
recording, the photo resolution is fixed to 8.3MP.
14
CAMERA OPERATION
Video Tagging
Video Tagging allows the camera to record video continuously, but save only the
important events.
It creates video files of past, present, and future with each footage having an
assigned length of time (3 minutes).
1
When you encounter an event that is worth saving, press and hold the
Camera Button for 3 seconds. You will hear a voice prompt, "Video
tagging".
2
When Video Tagging is completed, you will hear a voice prompt,
"Tagging complete".
NOTE
• Video Tagging can be operated only in the Loop Recording mode. In order for video
files of past, present, and future to be saved, Video Tagging must be started at least 3
minutes after Loop Recording starts.
• Video Tagging recorded files are stored in EVENT folder.
Advertisement
Table of Contents
