Table of Contents
Advertisement
TM
MatrixPRO
16x Series
6.5
MATRIXPRO
HELP
ALVL num lvl
AVTYPE mode
CLEAR
CSUMSTAT
FDLY dly
FPLOCK en
GCLEAR grp
GADD grp out in
GDEL grp out in
IPCONFIG I3 I2 I1 I0
LOADRMP
OMUTE out en
OSTAT [out]
PSTAT [num]
PRST num
RPRST num
RNOV
RESETMP op
RTEMP out in audio
SBAUD
SMODE mode [485id]
SWITCH mode
TAKE en
UNOV
VDLY dly
6.5.1
MATRIXPRO
Command:
HELP
Description:
Displays the list of available command on a terminal emulator
Parameters: None
Example:
HELP
Command:
ALVL num lvl
Description:
Updates input audio level
Parameters: num - Input number; [1 - 16]
lvl -
Query:
ALVL? num
Returns the selected input audio level in the format:
=lvl
Example:
ALVL 1 252
input 1 will have audio level of 252.)
TM
REMOTE COMMANDS
Capabilities. Send list of commands available back in ASCII format
Input Audio Level.
AV Type. 0=A/V, 1=Audio, 2=Video
Clear all matrix video and audio routings.
Display Main Code/RBF Checksum info
Field delay for RGB sync. Delay (dly) in milliseconds
Locks/unlocks Front Panel control
Clears grouping information
Add output, input to group
Remove output, input from group
IP address configuration I3.I2.I1.I0
Places unit into loader mode for firmware upgrade
Enable/disable audio mute on output.
Displays output status in ASCII.
Displays preset status in ASCII.
Saves current front panel configuration to a Preset location.
Recall preset from a Preset location.
Recall Flash settings
TM
Reset the MatrixPRO
Factory Reset
Route inputs to outputs. If output is in group, group is routed too.
Sets Baud Rate. 0=19200, 1=28800, 2=38400, 3=57600.
Serial Mode. 0=RS232, 1=RS485. [485id] opt if RS232
Switching Mode. mode = 0(RGB) 1(VSync) 2(Comp) 3(VREF In)
en = 1 simulates a TAKE button pushed on the front panel (i.e takes
all prelim routes and makes it permanent). en = 0 simulates a CANCEL
button pushed
Save current settings to FLASH
Vertical Interval delay. Delay for # of VSYNCs seen before raising /CE.
Minimum is 1, max is 255
TM
SERIAL COMMAND LIST/DESCRIPTION
(Returns the command list.)
Audio level; [0 - 252]
(Set input 1 audio level to 252. All outputs connected to
and recall saved Flash values op [R|F] Reset |
32
Manual #26-0301100-00/ Revision A
Advertisement
Table of Contents
