This product meets the requirements ANSI-Z359.1 and ANSI-A10.32, and should be used as part of an employee training program
as required by OSHA.
Figure 1 – SBT-161 Beam Trolley
1.0 APPLICATIONS
1.1 PURPOSE: The Trolley Anchorage Connector is
designed to move along horizontal beams with an attached personal fall arrest system. This trolley is to be used
only as a component of a personal fall arrest system. Do not hang, lift, or support tools or equipment from the
trolley.
A. FALL ARREST: The trolley is used as a component of a personal fall arrest system. Personal fall arrest
systems typically include a self retracting lifeline, connector to attach the self retracting lifeline to the trolley,
and full body harness. A personal fall arrest system is used where a free fall is possible before the fall is
arrested.
1.2 LIMITATIONS: Consider the following application limitations before using this equipment:
A. BEAMS: The trolley may be used on beam flanges 4 inches to 14 inches wide and up to 1 1/8 inches thick.
The beam structure must meet the strength requirements specified in section 2.4. The beam must be
horizontal and level.
B. CAPACITY: The trolley is designed for use by person with a combined weight (clothing, tools, etc.) of no
more than 310 lbs. Only one personal fall arrest system may be connected to a single trolley.
C. PERSONAL FALL ARREST SYSTEM: Personal fall arrest systems used with the trolley must meet the
system requirements as specified in section 2.5.
D. FREE FALL: Personal fall arrest systems used with the trolley must be rigged to limit the free fall to six feet.
E. FALL CLEARANCE: There must be sufficient clearance below the user to arrest a fall before the user strikes
the ground or other obstruction. The clearance required is dependent on the following factors:
• Elevation of Trolley
• Deceleration distance
• Worker height
F. TROLLEY LOAD ANGLE: Loads imposed on the trolley by the personal fall arrest system must remain within
thirty degrees of the vertical center line of the beam. See Figure 2.
User Instruction
Gemtor Beam Trolley
• Connecting subsystem length
• Movement of harness attachment element
• Free fall distance
emtor, Inc. • One Johnson Avenue • Matawan, NJ 07747
G
Phone: 732-583-6200 • 800-405-9048 • Fax: 732-290-9391
Web: www.gemtor.com • Email: sales.info@gemtor.com
WARNING: This product is part of a personal fall
arrest
system.
The
manufacturer's instructions for each component of
the system. These instructions must be provided to
the user of this equipment. The user must read and
understand these instructions before using this
equipment. Manufacturer's instructions must be
followed for proper use and maintenance of this
equipment. Alterations or misuse of this equipment,
or failure to follow instructions, may result in serious
injury or death.
IMPORTANT: If you have questions on the use,
care, or suitability of this equipment for your
application, contact Gemtor, Inc.
user
must
follow
the