Analog Output Setting; Automatic Display Darkening Setting; Automatic Power Saving Setting - Esoteric D-02X Owner's Manual

Setting mode (continued)

Analog output setting

AOUT>***
Use this to select the analog output connectors to be used .
By default, the setting is XLR2 .
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT .
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT .
RCA
Analog audio signals are output through the RCA connectors .

Automatic display darkening setting

DPaOFF>***
You can set the display to darken automatically after a set amount of
time has elapsed .
By default, the setting is ON .
ON
The display will automatically darken after 10 minutes elapse with-
out any operation or change in the information shown .
OFF
The display will not automatically darken, but if nothing changes
on it for 10 minutes, its brightness will be lowered to the level of
Dimmer1 to reduce long-term display fading .
o We recommend setting this to "ON" because brightness irregulari-
ties might occur if the same information is shown without change
on the display for a long time .
16

Automatic power saving setting

APS>***
The unit can be set to turn off automatically if the set amount of time
elapses without being able to lock to a digital signal from an input
source .
By default, the setting is 30 .
30
The unit will automatically turn off if 30 minutes elapse without
playback or other operation .
60
The unit will automatically turn off if 60 minutes elapse without
playback or other operation .
90
The unit will automatically turn off if 90 minutes elapse without
playback or other operation .
120
The unit will automatically turn off if 120 minutes elapse without
playback or other operation .
OFF
The automatic power saving function is disabled .