Operation - SoftBank ADP-50ER Manual

BATTERY CHARGER
GUIDE
For ADP-50ER and ADP-50MR charger versions
See the reference number underneath your charger.
General Technical
Charger ADP-50ER
Specifications
Input Voltage Range 100-240 V AC
Output Voltage 24.8 V DC (25.2 V DC fully charged)
Output Current 2.0 A
Casing Dimensions 135 x 62 x 34 mm
DC Cable Length 1.80 m
Weight 400 g
Working Temperature - 5 °C to + 40 °C
Casing Material Plastic
4
NAO Charger 20190516.indd 4
Power Connector Socket
Battery Charger Casing
LED
Battery Charger Cable
Battery Charger Connector
Power Cable
Power Connector
Plug
Charger ADP-50MR
155 x 67 x 37 mm
500 g
CHARGING NAO
• Insert the plug into the wall socket (1).
• Insert the Connector into the Robot (2).

OPERATION

The Battery Charger may become warm when charging. Please refer to the
following table concerning the LEDs functioning.
LED Color ADP-50ER Charger
Charger not connected to
Solid green the Robot or Battery fully
charged.
Flashing
-
green
Solid red Battery is charging.
PROTECTION AND RESET
When the LED is off but the Charger is connected, the following protections
may have triggered:
Overvoltage
Shortcircuit
Overcurrent
Reverse Voltage
Temperature
1
2
ADP-50MR Charger
Battery is fully charged.
Charger not connected to the
Robot.
To reset the Charger, disconnect from
the wall socket and reconnect.
To reset the Charger, disconnect from
the wall socket and reconnect. War-
ning! The Charger may be permanently
damaged.
Unplug the Charger and wait until tem-
perature decreases below +40°C. To
reset the Charger, unplug and replug
the wall socket.
17/05/2019 12:36:04