Step 1: With the MCCB breaker exposed, ensure that the breaker is free from any obstruction that may interfere with the proper installation of the RSA-174F. Step 2: Next, prepare the RSA-174F for installation by extracting the black knob on the upper locating arm and lowering the upper locator.
Page 3
Step 5: Next, rotate the RSA assembly toward the breaker until the frame sits flat against the breaker as shown below and the handle sits between the RSA-174F rollers. ATTENTION! The location of certain items such as mimic bus, stickers, and/or placards may interfere with the installation of the remote operating equipment.
Page 4
Step 5: Lastly, ensure that the device is setup as shown below. If everything is setup as described above and shown below then the RSA-174F is ready to operate. Page | 4 RSA-174F Manual – ABB/Sace T-Max T7 (OTM Mechanism)
2.0 Operation Step 1: Ensure that the RSA-174F is properly installed on the breaker as described in the previous section. Step 2: Next, open the RSO-I AR to expose the cords and controls by disengaging the two latches on the front panel and lifting the lid.
Page 6
Federal, State, Local, and In-house safety regulations and procedures. Attention should be given to distance, angle, and personal protective equipment (PPE). Page | 6 RSA-174F Manual – ABB/Sace T-Max T7 (OTM Mechanism)