Table of Contents
Advertisement
You can use your music system as a
stand-alone system or as a Audio/
Video system, if you connect the
systems with a Master Link cable. If
you connect your music system and
your video system, you must make
sure that they are set up to function
together. This means that you have
to make Option programming as
described on this page. You also
choose whether to connect your
loudspeakers to your music system or
your video system.
Your music system is set for Option 1 from
the factory and you do not have to make
Option programming if you are using your
music system on its own.
Refer to the chapter Use an Audio/Video
system on page 24 for information on how
to operate an Audio/Video system.
Audio/Video setup
Option programming
Option programming is done with the Beo4
remote control and with the entire system
switched to standby.
To program 'Option' for your audio system...
> While holding down the • button, press LIST.
> Let go of both buttons.
> Press LIST repeatedly until OPTION? is shown in
the Beo4 display and press GO.
> Press LIST repeatedly until A.OPT is shown in the
Beo4 display and then key in the appropriate
number (0, 1 or 2).
Choose V.OPT to program 'Option' for your video
system.
The music system has three different Option
settings:
Option 0. Used when your music system is
connected to your video system and no speakers
are connected directly to your music system.
Option 1. Used when your music system is set up
on its own or connected to a video system,
when speakers are connected to your music
system.
Option 2. Used when your music system is set up
in one room and connected to a video system
set up in another room.
Option 2
Option 0
An Audio/Video system.
Option 1
A stand-alone setup.
Option 1
Option 1
An Audio/Video system set up in one room.
Option 2
An Audio/Video system set up in two rooms.
29
Option 2
Hide quick links:
Advertisement
Table of Contents
