Advertisement
Install R55 the 41.2K ohm (Yellow-Brown-Red-Red-Brown) resistor in the marked location on the board
Install R56, the 100K resistor (Brown-Black-Black-Orange-Gold) in the marked location on the board.
Note: R56 is now a 1% resistor and has a blue body. The photo below shows a 5% resistor for R56.
Install C1 the 0.01uF capacitor in the location marked on the board.
Install the 4 pin Header in the location SV1. You will find it helpful to just solder 1 pin and then make sure
it is straight and flush to the board. If not, reheat that pin and adjust the header for alignment before
soldering the additional pins.
Now, solder the BNC connector, making sure to seat it fully into the board. Solder the two small wires
and the two support pins.
The support pins may require longer time, increased temperature or a larger soldering iron to properly
solder.
Congratulations, your dummy load kit is now complete!
DummyLoad20190402
3
Advertisement
