Eliminating Minor Faults Yourself - Siemens KI25R Series Instructions For Use Manual

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
Appliance is not
cooling, temperature
display and light
are lit.
The temperature in
the refrigerator
compartment is too
cold.
The refrigerating unit
is switching on more
frequently and for
longer.
The light
does not function.
Possible cause
Showroom mode is
switched on.
Temperature has been
set too low.
Appliance opened
frequently.
The ventilation
openings have been
covered.
The LED light
is defective.
Appliance was open
too long.
Light is switched off
after approx. 10 min.
Remedial action
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
Hold down temperature selection
button fig. 2/3 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
Increase the temperature.
Do not open the appliance
unnecessarily.
Remove obstacles.
See chapter "Light (LED)" section.
When the appliance is closed
and opened, the light is on again.
en
29