Advertisement
Available languages
Available languages
INSTALLATION
Notes:
Choose the mounting location where
the unit will not interfere with the
normal driving function of the driver.
Before
finally
connect the wiring temporarily and
make sure it is all connected up
properly and the unit and the system
work properly.
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if
installation requires the drilling of holes
or other modifications of the vehicle.
Install the unit where it does not get in
the driver's way and cannot injure the
passenger if there is a sudden stop,
like an emergency stop.
If installation angel exceeds 30°from
horizontal, the unit might not give its
optimum performance.
Avoid installing the unit where it would
be subject to high temperature, such
as from direct sunlight, or from hot air,
from the heater, or where it would be
subject to dust, dirt or excessive
vibration.
DIN FRONT/REAR-MOUNT
This unit can be properly installed either
from "Front" (conventional DIN
Front-mount) or "Rear"(DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis). For details,
refer to the following illustrated installation
methods.
installing
the
unit,
30
DIN FRONT-MOUNT (Method A)
Installation Opening
This unit can be installed in any dashboard
having an opening as shown below:
182mm
Installing the unit
Be sure you test all connections first, and
then follow these steps to install the unit.
1.ke sure the ignition is turned off, and then
disconnect the cable from the vehicle
battery's negative (-) terminal.
2.sconnect the wire harness and the
antenna.
3.ft the top of the outer trim ring then pull it
out to remove it.
4.e two supplied keys release tabs inside
the unit's sleeve so you can remove it.
Insert the keys as far asthey will go (with
the
notches
appropriate slots at the middle left and
right sides of the unit. Then slide the
sleeve off the back of the unit.
L Key
Outer Trim Ring
5.unt the sleeve by inserting the sleeve into
the opening of the dashboard and bend
open the tabs located around the sleeve
with a
17
53mm
facing
up)
into
Sleeve
R Key
the
Advertisement
