Advertisement
SAFETY STRAP AND SUPPORT STRAP INSTRUCTIONS
• Note: There are two (2) safety straps with weld nuts and
three (3) recessed shelf support straps on the bottom set
of crossbeams.
• Note: There are two (2) safety straps with weld nuts and
four (4) bench top support straps on the top set
of crossbeams.
• Note: Top and bottom crossbeams use different support straps.
STEP 1
• Starting with the bottom set of crossbeams, place a safety
strap with weld nut between the lower ridges of the crossbeams
where two sets of holes have been pre-drilled. Thread a safety
strap bolt up through the bottom of the pre-drilled holes and
through the weld nuts, and fully tighten with the included
hex key or drill bit. Repeat for the second strap on this set of
crossbeams, and continue for the last 3 straps.
STEP 2
• On the bottom of the bench, place a recessed shelf support
strap (yellow) perpendicular to the bottom crossbeams,
and insert each end into the channel on each ridge of the
crossbeam. Repeat for the remaining 2 (yellow) straps.
STEP 3
• On the top of the bench, place a bench top support strap
(black) perpendicular to the top crossbeams, and insert each
end into the channel on each ridge of the crossbeam. Repeat
for the remaining 3 (black) straps.
BENCH TOP
SUPPORT STRAPS (BLACK)
SAFETY STRAP
WITH WELD NUT
RECESSED SHELF
SUPPORT STRAPS
(YELLOW)
CROSSBEAM
SAFETY STRAP
WITH WELD NUT
RECESSED SHELF
SUPPORT STRAPS ON
BOTTOM CROSSBEAMS
TOP BENCH
SUPPORT STRAPS ON
TOP CROSSBEAMS
9
Advertisement
