Threading Welding Wire - Hobart IronMan 240 Owner's Manual

5-12. Threading Welding Wire

Open pressure assembly.
Close and tighten pressure
assembly, and let go of wire.
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle
.
A complete Parts List is available at www.HobartWelders.com
1
2
3
5
.
Hold wire tightly to keep it
from unraveling.
Pull and hold wire; cut off end.
.
Tighten
Use pressure indicator
scale to set a desired
drive roll pressure.
1
2
3
4
Remove gun nozzle and contact tip.
WOOD
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
4
7
6
6 in.
(150 mm)
Push wire thru guides into gun;
continue to hold wire.
Pressure
Indicator
Scale
Tighten
1
2
3
4
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Outlet Wire Guide
7 Gun Conduit Cable
Lay gun cable out straight.
Tools Needed:
Turn On.
Cut off wire. Close
and latch door.
Ref. 804913-B
OM-284833 Page 21